BTc Controls| EP1.x Electronic Stroke Limit Control

The EP1.x Limit Switch control provides end of travel positioning through the use of a magnetic switch and motor mounted relay.

The EP1 limit switches are mounted in a channel on the actuator cover tube accessible below a durable cover. (for factory set limit switches see P1.0 designs). The EP1 switches are field adjustable.

The Electronic Stroke control package consists of the magnetic sensors and a motor mounted relay within an enclosure suited for harsh environments.

A Zener diode suppression is used on both input and outputs for added protection from electrical spikes. Unit reversing is achieved by reversing input power polarity to the motor.

Specifications:

Power:
25 amps max. @ 12 volts
12.5 amps max. @ 24 volts

Operating Temperature:
-30º to +140º F (-34ºC to 60ºC)

Options:

EP1.0 - Standard Stoke Limit Control

EP1.1- Same as P1.0 with two LEDs on the outside of the control module. LEDs indicate when end of travel has been reached.

EP1.2 - Same as P1.0 with two 12/24 volt, 0.5 amps outputs that can be used to signal an external switch, relay, lamp or PLC input.

EP1.2LE - Two +5 VDC 25ma outputs plus a ground to provide a signal when end of travel is reached. This output can be used to power LEDs.